TM 9-2520-246-34 Figure 5-5. Removal of Input Gearshaft. (2) Lift the gear from the case and remove the roller bearings from the gear, then remove the thrust washers from the respective positions. (See fig. 5-6.) d. Output and Reverse Shaft Rear Bearing Cap. (1) Remove the five capscrews and star washers securing the rear bearing cap to the power takeoff case. (See fig. 5-7.) Remove the rear bearing cap and cap gasket. Discard the gasket. NOTE On assembly, always install a new gasket. (2) Remove the output shaft rear bearing spacer in front of the output shaft rear bearing. e. Output Shaft Front Bearing Cap and Companion Flange Key. (1) Remove the output shaft key from the output shaft. (See fig. 5-8.) Figure 5-6. Removal of Input Gear, Gear Roller Bearings, and Thrust Washers. Figure 5-7. Removal of Output and Reverse Shaft Rear Bearing Cap. (2) Remove the four capscrews and star washers securing the output shaft front bearing cap to the power takeoff. Remove the output shaft front bearing cap and gasket. Discard the gasket. NOTE On assembly, always install a new gasket. NOTE Do not remove the output shaft front bearing cap unless seal replacement is required. If seal is to be replaced, remove with suitable tool. Install by pressing or driving against the seal with a wooden block. Figure 5-8. Removal of Output Shaft Front Bearing Cap and Companion Flange Key. 5-4