TM 9-2520-246-34-1 2-10. ASSEMBLY OF SUBASSEMBLIES. The following paragraphs from dust and assemble the transmission subassemblies. a. NOTE Keep all parts clean and protected from dust and dirt. Coat all bearings with multipurpose lubricant during assembly. Coat all oil seals with engine lubricating oil during assembly. Coat shafts and bores of gears with white lead pigment during assembly. Use new seals and snaprings during assembly. Input Shaft Assembly. FRAME 1 1. Set up input shaft (1) in hydraulic press as shown. 2. Press bearing (2) into place. 3. Take input shaft (1) out of press. GO TO FRAME 2 2-62