TM 9-2520-246-34-1 2-38. ASSEMBLY. This paragraph gives instructions for putting the transmission transfer power takeoff together and also has end play adjustment needed. NOTE Keep all parts clean and protected from dust and dirt. Coat all bearings with multipurpose lubricant during assembly. Coat oil seal, gear and shafts with engine lubricating oil during assembly. Coat shafts and bore of gear with white lead pigment during assembly. Use new seal and gasket during assembly. FRAME 1 1. Put in key (1). 2. Put bearing cone (2) and shaft (3) in hydraulic press as shown. NOTE Make sure that tapered end of bearing cone (2) is facing splined end of shaft (3). 3. Press shaft (3) into bearing cone (2). GO TO FRAME 2 2-364