TM 9-2520-246-34-1 2-34. CLEANING. This paragraph gives general instructions for cleaning the trans- mission transfer power takeoff parts. a. Clean all bearing cones and cups. Refer to inspection, care and maintenance of antifriction bearings, TM 9-214. WARNING Dry cleaning solvent is flammable. Do not use near an open flame. Keep a fire extinguisher nearby when solvent is used. Use only in well-ventilated places. Failure to do this may result in injury to personnel and damage to equipment. Do not use more than 30 psi of air pressure for drying parts. Eye shields must be worn when using compressed air. Eye injury can occur if eye shields are not used. CAUTION When scraping gasket material from surface of parts, be careful not to scratch or gouge the metal surface. b. Clean all other parts with solvent. Scrape all gasket material from surface of parts. Rinse parts in clean solvent and dry with compressed air. 2-35. GENERAL INSPECTION. This paragraph gives instructions to check for damage on the transmission transfer power takeoff carrier, gear shafts, and gears. CAUTION It is easy to damage what you are doing. you are experienced person with you. the equipment if you don’t know Do not try to do this task unless at it, or you have an experienced NOTE Small chips, burrs or scratches on gears and gear shafts can be repaired. Cracks in carrier castings that do not go into screw holes or openings can be repaired. If parts are damaged in any other way, throw away parts and get new ones. 2-358