TM 9-2520-246-34-1 2-29. REPAIR. This paragraph gives instructions for repairs that can be done on the transmission power takeoff. a. Smooth out any chips, scratches or burrs on gear shafts and gears with a honing stone. b. Weld cracks and small holes in housing castings. Refer to TM 9-237. c. Drill out any bolts broken off in tapped holes. d. Drill out threaded holes that are stripped or out-of-round to the next larger size and retap them. When putting transmission power takeoff together, use a bolt the size of the new tapped hole. 2-30. ASSEMBLY. This paragraph gives instructions for assembling the transmission power takeoff. NOTE Keep all parts clean and protected from dust and dirt. Coat all bearings with multipurpose lubricant during assembly. Coat all oil seals, gears and shafts with engine lubricating oil during assembly. Coat shafts and bores of gears with white lead pigment during assembly. Use new seals, thrust washers, and gaskets during assembly. FRAME 1 1. Tap two seals (1) in place. 2. Using hammer with wood block, tap two boots with retaining cups (2) into place. GO TO FRAME 2 2-321