TM 9-2520-246-34-1 FRAME 3 1. Measure 2. Measure NOTE Readings must be within limits given in table 2-45. The letter L indicates a loose fit and the letter T indicates a tight fit. If readings are not within given limits, throw away part and get a new one. fit of two bearings (1) in two gear bores (2). fit of four bearings (1 and 3) on input shafts bearing surface (4) in two places. 3. Measure fit of fork (5) on ring of synchronizer (6). END OF TASK Index Number 1 and 2 3 and 4 5 and 6 Table 2-45. Input Shaft Assembly Fits and Tolerances Item/Point of Measurement Fit of bearing gear bore Fit of bearing on input shaft Fit of fork on synchronizer Size and Fit of New Parts (inches) 0.0007T to 0.008L 0.0002L to 0.0009T 0.0160L to 0.0280L Wear Limit (inches) 0.0012L 0.0005L 0.06706 2-206