TM 9-2520-246-34-1 FRAME 2 NOTE Readings must be within limits given in table 2-18. The letter L indicates a loose fit and the letter T indicates a tight fit. If readings are not within given limits, throw away part and get a new one. 1. Measure front diameter (1) and rear diameter (2) of output shaft. 2. Measure fit of fork (3) in clutch groove (4). 3. Measure fit of bearing (5) on output shaft (1). END OF TASK Index Number 1 2 3 and 4 1 and 5 Table 2-18. Front Output Shaft Assembly Fits and Tolerances Item/Point of Measurement Front output shaft front diameter Front output shaft rear diameter Fit of fork in clutch groove Fit of bearing on output shaft Size and Fit of New Parts (inches) 1.7716 to 1.7721 1.245 to 1.246 0.058 to 0.073L 0.001T to O.0009T Wear Limit (inches) 1.7716 1.2435 0.088L None 2-178