TM 9-2520-246-34-1 FRAME 4 1. Slide fourth and fifth speed shifter shaft (1) through hole in cover (2) as tagged. Leave hole (3) uncovered. 2. Slide fork (4) onto shaft (1) as shown. 3. Put spring (5) and ball (6) into hole (3). Using screwdriver, hold ball down. Slide shaft (1) over ball and into place. 4. Ane setscrew hole in fork (4) with setscrew hole in shaft (1). Make sure tab on fork sets in slot in plate (7). Put in setscrew (8). 5. Using hammer and drift, tap in expansion plug (9). 6. Do steps 1 through 5 again for second and third speed shifter shaft (10). GO TO FRAME 5 2-83