1. Remove six screws (4) and support (5) from engine block (6). 2. Remove four screws (3) and (8), lockwashers (2) and (7), and supports (1) and (9) from transmission housing (10). Discard lockwashers (2) and (7). INSTALLATION 1. Install supports (1) and (9) on transmission housing (10) with four new lockwashers (2) and (7) and screws (3) and (8). Tighten screws (3) and (8) 205-215 lb-ft (278-292 N•m). 2. Install support (5) on engine block (6) with six screws (4). Tighten screws (4) 75-85 lb-ft (102-115 N•m). 3. Install water pump drivebelt (WP 0081 00). 4. Install vibration damper (WP 0303 00). 5. Install power plant (WP 0295 00). 0301 00-2 TM 9-2320-386-24-1-2 0301 00 ENGINE MOUNTS AND SUPPORT REPLACEMENT (Contd) REMOVAL