INSTALLATION WARNING Lifting device must have a weight capacity greater than the weight of the engine and transmission to prevent injury to personnel and damage to equipment. Do not put hands between engine mounts and frame when removing mounting brackets. Lifting device or jack failure may cause injury to personnel. CAUTION Do not raise engine more than 0.5 in. (13 mm). Failure to comply may result in damage to transmission, radiator, or related parts. 1. Apply a detergent and water solution to rubber mounting pads (8). 2. Partially position rubber mounting pads (8) on mounting brackets (9) and (17) by pressing down on rubber mounting pads (8) and rotating. 3. Install mounting brackets (9) and (17) on left and right sides of frame (14) with eight screws (13) and new locknuts (10). WARNING Use prybar to position engine during lowering operations. Lifting device failure may cause injury to personnel. 4. Position two washers (7) on rubber mounting pads (8), lower and remove transmission jack, and lower engine (1) to seat rubber mounting pads (8) on mounting brackets (9) and (17). 5. Align holes of engine mounts (6) and (16) with mounting brackets (9) and (17) and install with two screws (15), washers (11), and new locknuts (12). Tighten locknuts (12) 195 lb-ft (264 N•m). 6. Remove lifting device from chain. 7. Remove nut (4), screw (2), two washers (3), and chain from lifting eye (5). 8. Install rear of front propeller shaft (19) on transfer case flange (18) with four screws (21) and new locknuts (20). 9. Lower and secure hood (TM 9-2320-386-10). 0300 00-4 TM 9-2320-386-24-1-2 0300 00 ENGINE REAR MOUNTING PADS REPLACEMENT (Contd)