0300 00-2 TM 9-2320-386-24-1-2 0300 00 ENGINE REAR MOUNTING PADS REPLACEMENT (Contd) REMOVAL 1. Remove four locknuts (3), screws (4), and rear of front propeller shaft (2) from transfer case flange (1). Discard locknuts (3). 2. Swing rear of front propeller shaft (2) toward passenger side of vehicle and secure it to underside of vehicle to provide room for transmission jack. 3. Remove two locknuts (16), washers (15), and screws (19) from engine mounts (10) and (20) and mounting brackets (13) and (21). Discard locknuts (16). 4. Install chain on lifting eye (9) with two washers (7), screw (6), and nut (8). WARNING Lifting device must have a weight capacity greater than the weight of the engine and transmission to prevent injury to personnel and damage to equipment. Do not put hands between engine mounts and rubber mounting pads when removing mounting brackets. Lifting device or jack failure may cause injury to personnel. CAUTION Do not raise engine more than 0.5 in. (13 mm). Failure to comply may result in damage to transmission, radiator, or related parts. 5. Connect chain to lifting device. 6. Raise engine (5) until there is space between engine mounts (10) and (20) and rubber mounting pads (12) on left and right sides of frame (18). 7. Position transmission jack under transmission lifting point and raise jack just enough to support transmission. 8. Remove two washers (11) from mounting brackets (13) and (21) on left and right sides of frame (18). 9. Remove eight locknuts (14), screws (17), and mounting brackets (13) and (21) from left and right sides of frame (18). Discard locknuts (14). 10. Remove two mounting pads (12) from mounting brackets (13) and (21).