INSTALLATION 1. Install two rear mounts (4) on engine (1) with eight new lockwashers (2) and screws (3). 2. Install chain and lifting device on two lifting brackets (5). WARNING All personnel must stand clear during lifting operations. A swinging or shifting load may cause injury to personnel. Lifting device must have a weight capacity greater than 4,500 lbs (2043 kg). Failure to do so may cause injury to personnel and/or damage to equipment. NOTE Assistant will help with steps 3 through 5. 3. Raise engine (1) from support stands. 4. Position engine (1) over cradle (10) in lower container section (9) and align holes in cradle (10) with holes in front mount (14) and two rear mounts (4). 5. Lower engine (1) onto cradle (10). 6. Install washers (13) and (12) and screw (11) on cradle (10) and front mount (14). 7. Install four screws (8), new lockwashers (7), and nuts (6) on two rear mounts (4) and cradle (10). 8. Position new gasket (17) on lower container section (9). WARNING All personnel must stand clear during lifting operations. A swinging or shifting load may cause injury to personnel. 9. Install chain and lifting device on upper container section (16). 10. Install upper container section (16) on lower container section (9) with twenty-four washers (20), screws (15), new lockwashers (19), and nuts (18). TM 9-2320-386-24-1-2 0296 00 ENGINE AND CONTAINER REPLACEMENT (Contd) 0296 00-4