63. Remove nut (22), screw (12), and washer (11) from radiator (10) and install end of chain on radiator (10) with washer (11), screw (12), and nut (22). 64. Remove nut (7), screw (9), and washer (8) from radiator (10) and install end of chain on radiator (10) with washer (8), screw (9), and nut (7). 65. Install chain on lifting device. WARNING All personnel must stand clear during lifting operations. A snapped chain, or shifting or swinging load, may cause injury to personnel. CAUTION When installing radiator, avoid contact with the fan actuator hub. Contact between the radiator and fan actuator hub can cause damage to the radiator. 66. Lift radiator (10) and charged air cooler (13) from floor and lower into position in vehicle. 67. Install pivot mount (14) on support bracket (18) with four washers (16), screws (15), and new locknuts (17). 68. Install two screws (24), washers (1) and (5), new bushings front (2) and rear (4) halves, and new locknuts (6) on braces (3) and (23). 69. Install hose (21) on lower flange (19) of radiator (10) and tighten clamp (20). 70. Install screw (27), washer (28), new rear bushing half (29), new front bushing half (30), washer (31), and new locknut (32) on braces (25) and (26). Tighten locknut (32) 27-33 lb-ft (37-45 N•m). 71. Remove nuts (7) and (22), screws (9) and (12), washers (8) and (11), and chain from radiator (10), charged air cooler (13), and lifting device. 72. Install washers (8) and (11), screws (9) and (12), and nuts (7) and (22) on radiator (10). 8 9 ~ 10 11 12 ~ 13 14 16 15 17 18 ~ 19 20 21 ~ 22 24 1 2 3 ~ 4 5 6 7 LIFTING DEVICE CHAIN 23 TM 9-2320-386-24-1-2 0295 00 POWER PLANT REPLACEMENT (Contd) 0295 00-34