LUBRICATION •WARNING• Skysol-100 mixture is combustible. Use mechanical ventilation whenever product is used in a confined space, is heated above ambient temperatures, or is agitated. DO NOT use or store near heat, sparks, flame, or other ignition sources. Keep container sealed when not in use. Contact with Skysol-100 may cause skin irritation. Use chemical resistant gloves. In case of skin contact, remove any contaminated clothing and wash skin thoroughly with soap and water. Wash contaminated clothing before reuse. Eye contact may cause irritation, tearing, or blurring of vision. Use face shield or goggles when eye contact may occur. In case of eye contact, flush eyes with large amounts of water for at least fifteen (15) minutes or until irritation subsides. Inhalation may cause irritation to upper respiratory passages. DO NOT have food or drink in the vicinity. After cleaning has been accomplished, wipe all grease fittings clean with Skysol-100 (item 17, WP 0393 00) and lubricate vehicle in accordance with WP 0023 00. Remove excess grease after lubrication and before processing. PRESERVATION All critical unpainted metal surfaces must be protected during shipment. Use procedures and materials listed in a. and b. below. If the preservatives listed below are not available, oil or grease covered in WP 0023 00 may be used for this purpose, but are effective for only a few days; therefore, equipment protected must be closely watched for signs of corrosion. When selecting preservatives, use only those that will not damage the surface to which they are applied. a. Battery Leads. Disconnect both batteries (WP 0121 00). Each battery lead terminal, including the jumper lead ends, must be wrapped with tape (item 48, WP 0393 00). b. Miscellaneous Preservation. Coat all unpainted, exposed, or machined metal surfaces on the exterior of the vehicle with corrosion-preventive compound (item 19, WP 0393 00). PACKAGING Electrical Openings. Cover all electrical receptacles with tape (item 48, WP 0393 00) or with plastic caps which will afford the same degree of protection. PACKING Pack all Basic Issue Items (BII) and Additional Authorization List (AAL) items to prevent mechanical damage. SHIPMENT OF ARMY DOCUMENTS Prepare all army shipping documents accompanying vehicle in accordance with DA Pam 738-750. TM 9-2320-386-24-1-2 0387 00 GENERAL PREPARATION OF VEHICLE FOR SHIPMENT (Contd) 0387 00-2 END OF WORK PACKAGE