REMOVAL 1. Remove rear oil seal (5) from transmission (1). Discard oil seal (5). 2. Using snapring pliers, remove snapring (4) from transmission (1). 3. Remove bearing (3) from transmission (1). NOTE Replace retaining ring only if damaged. 4. Remove retaining ring (2) from transmission (1). If damaged, discard retaining ring (2). INSTALLATION 1. Install retaining ring (2) in transmission (1). 2. Install bearing (3) in transmission (1), with number side facing out. 3. Install snapring (4), flat side down, in transmission (1) with snapring pliers. 4. Install new oil seal (5) in transmission (1) with seal installer. ~ 1 2 3 4 5 0382 00-2 TM 9-2320-386-24-1-2 0382 00 TRANSMISSION OUTPUT SHAFT SEAL AND BEARING REPLACEMENT (Contd) END OF WORK PACKAGE