2. Install thrust washer (6) on front support (5). Ensure tab of thrust washer (6) engages cast recess of front support (5). 3. Install two new hook-type seal rings (7) on hub (8). 4. Apply lubricating oil on new seal ring (4). 5. Install seal ring (4) on front support (5). 6. Apply oil-soluble grease to hook-type seal rings (7) and thrust washer (6). 7. Install two guide screws (13) in opposite holes of transmission (1). 8. Install new gasket (12) on transmission (1). Ensure holes are aligned. 9. Install front support (5) on transmission (1) with seven washers (10) and screws (9). 10. Remove two guide screws (13 ) and install two washers (10) and screws (9). Tighten nine screws (9) 13-16 lb-ft (18-22 N•m). 11. Check turbine shaft end play: a. Position vernier caliper on turbine shaft (14). b. Raise turbine shaft (14), extend vernier caliper to stator shaft (11), and record reading. c. Release turbine shaft (14) and record reading. d. If the difference between steps b and c is not within 0.005-0.034 in. (0.13-0.86 mm), remove front support (5) and recalculate thickness of thrust washer (6) (step 1). 12. Install torque converter (WP 0368 00). 4 5 6 7 8 9 10 12 13 14 13 5 11 1 0374 00-11/12 blank TM 9-2320-386-24-1-2 0374 00 TRANSMISSION OIL PUMP MAINTENANCE (Contd) END OF WORK PACKAGE