ASSEMBLY NOTE Perform steps 1 through 3 if plug and bearing were removed previously. 1. Position lettered end of new bearing (4) up on stator hub (5). 2. Using bearing installer and driver handle, press bearing (4) into stator hub (5) to a depth of 0.595- 0.615 in. (15.11-15.62 mm) from end of stator hub (5). 3. Install plug (2) in oil passage port (1). 4. Install lockup valve (15), spring (14), and spring stop (13) in lockup valve bore (12) of front support (3). 5. Compress spring stop (13) against spring (14), and install dowel pin (6). 6. Install main-pressure regulator valve (7), spring (8), spring stop (9), and snapring (10) in regulator valve bore (11) of front support (3). 7. Install main-pressure regulator remover/installer on front support (3). Tighten screw of remover/installer to compress spring stop (9) against spring (8). 8. Install snapring (10) in regulator valve bore (11), loosen screw of remover/installer, and remove main-pressure regulator remover/installer from front support (3). 9. Install new oil seal (17) on seal installer and install oil seal (17) on oil pump (18), with lip facing inward. 10. Apply lubricating oil to drive gear (19), drive gear (20), and new seal ring (21). 11. Install seal ring (21) on oil pump (18). 12. Install drive gear (19) on oil pump (18), with internal tangs facing upward. 13. Install drive gear (20) on drive gear (19), with diamond-marked side facing downward. 14. Position oil pump (18) on front support (3), stator shaft (24), and spur gear (23), align holes, and install with five screws (22), six washers (25), and screws (16). Tighten screws (22) and (16) 15-20 lb-ft (20-27 N•m). 0374 00-8 TM 9-2320-386-24-1-2 0374 00 TRANSMISSION OIL PUMP MAINTENANCE (Contd)