78. Remove nut (5), ground strap (4), and lockwasher (3) from stud (1) on firewall (2). Discard lockwasher (3). 79. Slide collar (10) back and remove accelerator cable (12) from ball joint (8). 80. Remove cotter pin (6) and control cable pivot (9) from bracket (7). Discard cotter pin (6). 81. Remove two screws (14), washers (13), and bracket (15) with throttle control cable (11) and accelerator cable (12) from rear fuel pump housing (16). 82. Remove nut (30), lockwasher (31), STE/ICE-R harness lead 770-R (32), and engine harness lead 54-A (35) from fuel shutoff solenoid (17). Discard lockwasher (31). 83. Remove nut (20), lockwasher (19), and engine harness ground (GND) lead (18) from fuel shutoff solenoid (17). Discard lockwasher (19). 84. Disconnect STE/ICE-R connector lead (34) from fuel pressure sender connector leads (33). 85. Disconnect oil pressure sender lead 36 (21) from engine oil pressure transducer (22). 86. Remove nut (29), washer (28), STE/ICE-R harness (25), engine wiring harness (26), clamp (27), and ground (GND) lead (24) from stud (23). •WARNING• Diesel fuel is flammable. Do not perform fuel system procedures near open flames. Failure to comply may result in injury to personnel. NOTE Have drainage container ready to catch fuel. 87. Loosen nut (47) and remove fuel inlet hose (45) from elbow (44) on fuel pump (43). 88. Loosen nut (36) and remove fuel outlet hose (46) from elbow (37) on fuel pump (43). 89. Remove locknut (41), washer (40), screw (38), two clamps (39), fuel inlet hose (45), and fuel outlet hose (46) from bracket (42). Discard locknut (41). TM 9-2320-386-24-1-2 0295 00 POWER PLANT REPLACEMENT (Contd) 0295 00-18 ~ 6 7 8 9 10 11 12 13 14 ~ 15 1 2 5 4 3 16 ~