TM 9-2320-386-24-1-2 0335 00 TRANSMISSION (IN-VEHICLE) REPLACEMENT (Contd) 0335 00-14 20. Apply a bead of silicone rubber adhesive around mating surface of cover (10) and install cover (10) on flywheel housing (13) with four washers (12) and screws (11). 21. Install shift bracket (7) on transmission (5) with two new lockwashers (8) and screws (9). Tighten screws (9) 10-15 lb-ft (14-20 N • m). 22. Install manual control lever (14), with shift cable (6) attached, on shaft (17) with washer (16) and nut (15). 23. Install new packing retainer (4) and modulator (1) on transmission (5) with clamp (3) and screw (2). 24. Connect two leads 74A and 74B (30) to neutral safety switch leads 74A and 74B (29). 25. Secure two leads (30) and (29) to shift bracket (7) with clamp (27), screw (26), and new locknut (28). 26. Apply sealant to male threads of elbows (23), (25), and (33) and tee (22). 27. Connect oil inlet hose (21) and oil outlet hose (20) to elbow (23) and tee (22). 28. Connect lead 324 (18) to temperature switch (19). 29. Connect leads 380 and 380A (31) to backup light switch (32). 30. Connect secondary exhaust vent tube (24) to elbow (25). NOTE Assistant will help with steps 28, 33, and 34. 31. Connect air line (34) to elbow (33) on air compressor (35) and union (38). 32. Install air line (34) on bracket (42), frame rail (37), and transfer case mount (44) with clamp (45), screw (43), and new locknut (46). 33. Install air line (34) on engine oil pan (36) with clamp (39), washer (40), and screw (41). 1 2 3 4 5 6 7 8 15 14 16 17 9 13 11 12 10 18 19 28 21 20 22 23 24 25 7 27 26 30 29