TM 9-2320-386-24-1-2 0335 00 TRANSMISSION (IN-VEHICLE) REPLACEMENT (Contd) 0335 00-10 INSTALLATION WARNING Keep rear of transmission tilted slightly downward to prevent converter from separating from transmission and causing injury to personnel or damage to equipment. NOTE Check that converter has not moved forward before and after installing retaining brackets. Measure distance from flat on converter to lip on transmission housing. Distance cannot be more than 1.5 in. (38 mm). 1. Install two retaining brackets (4), one at 4 o’clock position and one at 8 o’clock position, on transmission (1) and converter (7) with four washers (3) and (5) and screws (2) and (6). NOTE Assistant will help with steps 2 through 15. 2. Position transmission (1) under vehicle. 3. Install transmission lifting fixture on transmission (1) with two screws (9) and screw (8), and connect sling in number two front hole and rear hole of transmission lifting fixture. Install sling to lifting device. 4. Adjust sling to lift transmision (1), with front end of transmission tilted downward. WARNING All personnel must be clear from under transmission during lifting, moving, and lowering operations. A snapped cable strap, chain, or shifting load may cause injury to personnel. 5. Lift up transmission (1) using transmission lifting fixture, sling, and lifting device into position. WARNING No personnel is to be under transmission until transmission jack has been installed. Failure to do so may cause injury to personnel. a. Adjust sling to lift up rear of transmission (1) first, and lift up rear of transmission (1) between flywheel housing (12) and rear braces (10) and (11). WARNING Do not place fingers or hands between transmission and flywheel housing or between rear braces at rear of transmission when moving transmission forward or lowering transmission. Doing so may cause injury to personnel. b. Adjust sling and move rear of transmission (1) slightly right to clear brace (10) as front of transmission (1) is moved slightly left to clear converter (7) from flywheel housing (12) and lift transmission (1). c. Move transmission (1) rearward and adjust sling to align transmission (1) with flywheel housing (12). CONVERTER TRANSMISSION HOUSING 1.5-in. (38mm)