1 2 2 3 5 6 7 8 ~ 9 8 4 3 17 11 16 15 ~ 14 13 12 10 10 8. Position two clamps (3) on wiring harness (10) and install three clamps (3) on crossmember (9) with two screws (8) and new locknuts (2). 9. Install two ground (GND) leads (4) on crossmember (9) with new lockwasher (6), screw (5), and new locknut (7) and install new tiedown straps (1), as necessary, to remove slack in wiring harness (10). 10. Position clamp (14) on wiring harness (10) and install clamp (14) on bracket (15) with screw (16), washer (13), and new locknut (12). 11. Connect harness plug with leads 27 and ground (GND) (17) to manifold power harness connector (11). TM 9-2320-386-24-1-2 0332 00 REAR WIRING HARNESS REPLACEMENT (Contd) 0332 00-8