NOTE Vehicles may come equipped with a Leece-Neville or Prestolite alternator. The STE/ICE-R wiring harness leads are connected to negative and positive posts on either alternator. 17. Install STE/ICE-R harness lead 770-N (12) and positive lead 2 (11) on stud (13) with new lockwasher (10) and nut (9). 18. Install STE/ICE-R harness lead 770-P (15) and ground (GND) lead (4) on alternator (14) with new lockwasher (6) and screw (5). Tighten screw (5) 45-55 lb-in. (5-1-6.2 N•m). NOTE Perform steps 19 through 21 for Prestolite alternators only. 19. Install plate (1) on alternator (14) with two new lockwashers (2) and screws (3). Tighten screws (3) 30-35 lb-in. (3.4-3.9 N•m). 20. Pack cover plate (8) with sealing compound. 21. Install cover plate (8) on alternator (14) with two new assembled-washer screws (7). NOTE Perform steps 22 and 23 for Leece-Neville alternators only. 22. Pack cover plate (8) with sealing compound. 23. Install cover plate (8) on alternator (14) with two new lockwashers (18) and screws (7). 24. Connect STE/ICE-R plug lead 770-O (17) to Y-connector (16). 25. Install STE/ICE-R terminal lead 770-T (22) on post (23) with new lockwasher (21) and nut (20). 26. Install STE/ICE-R terminal lead 770-M (26) on post (27) with new lockwasher (25) and nut (24). 27. Install STE/ICE-R terminal lead 770-S (30) on post (31) on starter solenoid (19) with new lockwasher (29) and nut (28). PRESTOLITE LEECE-NEVILLE TM 9-2320-386-24-1-2 0331 00 STE/ICE-R WIRING HARNESS REPLACEMENT (Contd) 0331 00-12 1 2 3 4 5 11 9 17 5 12 16 17 14 12 8 15 4 14 13 10 9 8 7 6 16 6 13 10 7 18 11 15