8. Install clamp (2) on STE/ICE-R wiring harness (5), engine wiring harness (6), and firewall (4) with screw (1) and new locknut (3). 9. Install clamp (9) on STE/ICE-R wiring harness (5), engine wiring harness (6), and bracket (11) with screw (10) and new locknut (8). 10. Install tiedown straps (7) on wiring harnesses (5) and (6) as necessary to secure wiring harnesses. 11. Install exhaust flex elbow (13) and new gaskets (15) and (16) on turbocharger (14) and inlet on exhaust pipe (17) with two clamps (12). 12. Install clamp (24) on STE/ICE-R wiring harness (5), engine wiring harness (32), and clamp (33) on stud (29) with new locknut (34). 13. If quick-start bracket (28) was removed, install quick-start bracket (28), new lockwasher (30), and ground strap (31) on engine (27) with four new lockwashers (26) and screws (25). 14. Install engine harness ground (GND) terminal (35), clamp (36) with STE/ICE-R wiring harness (5), and engine wiring harness (32) on stud (23) with new lockwasher (37) and new locknut (38). 15. Connect fuel pressure sender connector (39) to STE/ICE-R harness connector plug (40) with leads 770-F, 770-G, 770-U, and 770-V. 16. Install wiring harness lead 54A (18) and STE/ICE-R terminal lead 770-R (19) on stud (20) with new lockwasher (21) and nut (22). 1 2 3 4 ~ 9 8 7 5 6 11 ~ 10 TO STE/ICE-R SHUNT TO FUEL PRESSURE SENDER AND FUEL SOLENOID TO STARTER AND ALTERNATOR TM 9-2320-386-24-1-2 0331 00 STE/ICE-R WIRING HARNESS REPLACEMENT (Contd) 0331 00-10