NOTE Vehicles may come equipped with a Leece-Neville or Prestolite alternator. The STE/ICE-R wiring harness leads are connected to negative and positive posts on either alternator. All waterproofing must be removed from wires. 7. Disconnect STE/ICE-R plug with lead 770-O (17) from Y-connector (16). NOTE Perform steps 8 and 9 for Prestolite alternator only. 8. Remove two screws (3), lockwashers (2), and plate (1) from alternator (14). Discard lockwashers (2). 9. Remove two assembled-washer screws (7) and cover plate (8) from alternator (14). Discard assembled-washer screws (7). NOTE Perform step 10 for Leece-Neville alternators only. 10. Remove two screws (7), lockwashers (18), and cover plate (8) from alternator (14). Discard lockwashers (18). 11. Remove nut (9), lockwasher (10), positive lead 2 (11), and STE/ICE-R harness lead 770-N (12) from positive post (13). Discard lockwasher (10). 12. Remove screw (5), lockwasher (6), ground (GND) lead (4), and STE/ICE-R harness lead 770-P (15) from alternator (14). Discard lockwasher (6). 13. Remove nut (28), lockwasher (29), and STE/ICE-R terminal lead 770-S (30) from post (31) on starter solenoid (19). Discard lockwasher (29). 14. Remove nut (24), lockwasher (25), and STE/ICE-R terminal lead 770-M (26) from ground post (27). Discard lockwasher (25). 15. Remove nut (20), lockwasher (21), and STE/ICE-R terminal lead 770-T (22) from post (23). Discard lockwasher (21). 1 2 3 4 5 11 9 17 5 12 16 17 14 12 8 15 4 PRESTOLITE LEECE-NEVILLE TM 9-2320-386-24-1-2 0331 00 STE/ICE-R WIRING HARNESS REPLACEMENT (Contd) 0331 00-4 14 13 10 9 8 7 6 16 6 13 10 7 18 11 15