81. Connect wires 118 (37), 74 (36), 74A (35), and 117 (34) to starter switch (29). 82. Position starter switch (29) on instrument panel (15) with alignment pin (28) in alignment hole (27) and install switch plate (26), new lockwasher (30), and nut (31). 83. Install handle (32) on starter switch (29) with new lockwasher (25) and screw (33). 84. Install resistor lead (40) on top position of personnel heater switch (41) with new assembled-washer screw (39). 85. Install lead 400 (49) on center position of personnel heater switch (41) with new assembled-washer screw (38). 86. Install resistor lead and lead 400A (47) on personnel heater switch (41) with new assembled-washer screw (48). 87. Install personnel heater switch (41) on mounting bracket (46) under instrument panel (15) with switch plate (42), locking ring (45), new lockwasher (44), and nut (43). 38 48 25 26 27 28 15 30 31 32 33 LOAD PORT B BATTERY POIRT D LAMP PORT C GROUND PORT A 29 29 34 35 36 37 39 40 41 15 42 43 44 45 46 47 49 TM 9-2320-386-24-1-2 0330 00 FRONT WIRING HARNESS REPLACEMENT (Contd) 0330 00-31