40. Install leads 57A (35) and 770-R (36) on fuel shutoff solenoid terminal (38) with new lockwasher (34) and nut (33). 41. Install ground (GND) lead (2) on fuel shutoff solenoid terminal (1) with new lockwasher (3) and nut (4). 42. Position clamp (30) on wiring harnesses (29) and (37) and install ground (GND) lead (39) and clamp (30) on mounting stud (7) with new lockwasher (31) and nut (32). 43. Connect oil pressure sender lead 36 (5) to oil pressure transducer (6). 44. Position clamp (12) on wiring harnesses (29) and (37) and position clamp (27) on magnetic speed sensor lead with plug (25). Install clamps (12) and (27) on mounting stud (13) with new locknut (28). NOTE If quick-start bracket was mounted on engine, perform step 45 to replace quick-start bracket. 45. Install quick-start bracket (10), new lockwasher (14), and ground strap (15) on engine (11) with four new lockwashers (9) and screws (8). 46. Connect wiring harness plug with leads 429 and 428 (26) to magnetic speed sensor plug (25). 47. Connect plug with leads 569 and 569B (17) to quick-start unit connector (16). 48. Position clamp (18) on wiring harness (24) and on neutral safety switch leads (22). Install clamp (18) on transmission shift lever (20) with screw (19) and new locknut (21). 49. Connect wiring harness leads 74A and 74B (23) to two neutral safety switch leads (22). TM 9-2320-386-24-1-2 0330 00 FRONT WIRING HARNESS REPLACEMENT (Contd) 0330 00-26 2 4 23 25 24 26 27 28 29 30 33 32 31 3 5 7 8 9 10 11 12 13 14 15 16 17 18 19 22 6 1 20 21 35 37 38 39 36 34