NOTE All waterproofing must be removed from wires. Vehicles may come equipped with a Leece-Neville or Prestolite alternator. The wiring harness leads are connected to negative and positive posts on either alternator. 21. Disconnect lead 1 (21) from Y-connector (20). NOTE Perform steps 22 and 23 for Prestolite alternators only. Perform step 24 for Leece-Neville alternators only. 22. Remove two screws (3), lockwashers (2), and plate (1) from alternator (10). Discard lockwashers (2). 23. Remove two assembled-washer screws (6) and cover plate (5) from alternator (10). Discard assembled-washer screws (6). 24. Remove two screws (6), lockwashers (22), and cover plate (5) from alternator (10). Discard lockwashers (22). 25. Remove nut (7), lockwasher (8), and positive lead 2 and STE/ICE-R lead 770-N (4) from alternator terminal post (9). Discard lockwasher (8). 26. Remove nut (15), screw (11), two lockwashers (12), and ground (GND) leads (13) from frame rail (14). Discard lockwashers (12). 27. Remove locknut (17), clamp (16), and screw (18) from frame rail (14) and cable (19). Discard locknut (17). 28. Remove nut (26), lockwasher (25), and positive cable lead, harness lead, and relay lead 14 (24) from starter solenoid terminal (23). Discard lockwasher (25). LEECE-NEVILLE 23 25 26 24 1 2 3 5 6 4 7 8 9 10 ~ 14 12 15 17 16 18 19 20 21 7 8 4 6 22 5 9 10 20 21 PRESTOLITE ~ ~ TM 9-2320-386-24-1-2 0330 00 FRONT WIRING HARNESS REPLACEMENT (Contd) 0330 00-6 11 12 13