8. Disconnect lead 19 (27) from blackout light (26). 9. Remove nut (22), lockwasher (23), and ground (GND) lead (24) from blackout light mounting post (25). Discard lockwasher (23). 10. Remove locknut (18), clamp (19) with wiring harness (17), and screw (20) from blackout light mounting bracket (21). Discard locknut (18). 11. Remove locknut (14), clamp (15) with wiring harness (17), and screw (16) from fender mounting bracket (28). Discard locknut (14). 12. Route wiring harness (17) through grommet (30). NOTE For vehicles with a winch, the blackout light wiring harness will run inside the frame rail and one additional clamp assembly must be removed. 13. Remove four locknuts (10), screws (4), and shield (8) from fender (7). Discard locknuts (10). 14. Route wiring harness (5) through fender grommet (6). 15. Route wiring harness (5) through shield grommet (9). 16. Remove locknut (13), clamp (12) with wiring harness (5), and screw (11) from fender mounting bracket (28). Discard locknut (13). 17. Route wiring harness (5) through grommet (30). 18. Remove tiedown straps (31), as necessary. Discard tiedown straps (31). 19. Disconnect lead 25 (32) from steering column lead 25 (33). 20. Remove nut (3), screw (1), two ground (GND) leads (34), and two lockwashers (2) from frame rail (29). Discard lockwashers (2). TM 9-2320-386-24-1-2 0330 00 FRONT WIRING HARNESS REPLACEMENT (Contd) 0330 00-4