TM 9-2320-386-24-1-2 0330 00 FRONT WIRING HARNESS REPLACEMENT (Contd) NOTE For additional wiring harness replacement information, refer to WP 0386 00, Electrical System Wiring Diagram. REMOVAL NOTE Tag all leads for installation. Route wires back to closest clamp after disconnection. Left and right sides are replaced the same. Steps 1 through 18 are for left side. 1. Remove four locknuts (11), screws (3), and headlight mounting bracket (1) from fender (10). Discard locknuts (11). 2. Remove locknut (13), ground (GND) leads (14) and (15), lockwasher (16), and screw (2) from headlight mounting bracket (1). Discard locknut (13) and lockwasher (16). 3. Disconnect composite light leads 491, 20, and 460 on right side (4) or 461 on left side (4) from harness leads 491, 20, and 460 on right side (5) or 461 on left side (5). 4. Disconnect harness leads 17 and 18 (6) from headlight lamp (17). 5. Disconnect marker light lead 489 (8) from harness lead 489 (7). 6. Remove wiring harness (9) from headlight mounting bracket (1). 7. Route wiring harness (9) over to grommet (12) on fender (10). 0330 00-2