7. Remove clip (1) from sleeve (3). 8. Using soft-jawed pliers, rotate sleeve (3) back and forth to break loose O-ring (5). 9. Using soft-jawed pliers, slide sleeve (3) into cylinder head (2). 10. Remove retaining ring (9) and pin (6) from clevis (8) and link (4). Discard retaining ring (9). 11. Remove O-ring (5) from sleeve (3). Discard O-ring (5). CAUTION Use care not to damage fuel injector control linkage when removing governor. 12. Remove three screws (15), washers (16), governor (7), O-ring (10), and three sleeves (17) from front housing (11). Discard O-ring (10). 13. Remove inlet fitting (18) and check valve (20) from governor (7). Discard check valve (20). 14. Remove O-ring (19) from inlet fitting (18). Discard O-ring (19). 15. Remove outlet fitting (12) and check valve (14) from governor (7). Discard check valve (14). 16. Remove O-ring (13) from outlet fitting (12). Discard O-ring (13). 0326 00-4 TM 9-2320-386-24-1-2 0326 00 GOVERNOR REPLACEMENT (Contd)