NOTE If the control linkage positioning tool is left in position, it will interfere with rack movement and prevent an accurate check or adjustment of the fuel setting. 16. Loosen clamping screw on control linkage positioning tool. 17. Remove control linkage positioning tool from control linkage shaft (5). 18. Remove clip (2) from governor sleeve (1). 19. Using soft-jawed pliers, rotate sleeve (1) back and forth to break loose the O-ring seal on sleeve (1). NOTE Ensure no nicks or scratches occur to sleeve while sliding sleeve into intake manifold. Damage to sleeve may result in governor not sealing properly. 20. Using soft-jawed pliers, slide sleeve (1) from governor (4) into cylinder head (3). 21. Install fuel setting pin in pin (6). NOTE Do not force the fuel setting wedge in too far. The wedge needs to be in tight enough to hold the pin securely against the governor housing, but too much pressure may cause the pin to flex and distort the fuel setting reading. 22. Install fuel setting wedge between sleeve (1) and fuel setting pin. Ensure fuel setting wedge is positioned to hold fuel setting pin securely against governor (4). 1 2 3 4 ~ 0323 00-6 TM 9-2320-386-24-1-2 0323 00 FUEL SETTING ADJUSTMENT (Contd)