.WARNING. Diesel fuel is flammable. Do not perform fuel system procedures near open flame. Injury to personnel may result. NOTE All fuel injectors are replaced in the same way. This procedure is for the replacement of one fuel injector. REMOVAL 1. Loosen three jamnuts (6) and back out three adjusting screws (8) on rocker arm assembly (5). NOTE Anchor is only installed on No.1 cylinder rocker arm assembly. Support rocker arm assembly during removal to prevent damage. Tag pushrods for installation. 2. Remove four screws (3), anchor (4), rocker arm assembly (5), fuel injector pushrod (1), and two valve pushrods (2) from cylinder head (7). 3. Remove injector holddown screw (9) from cylinder head (7) and fuel injector holddown bracket (14). CAUTION Do not pry on injector holddown bracket. Use notch on opposite side of injector for prying the injector loose. Failure to do so may result in damage to equipment. Do not move fuel injector rack without slightly compressing injector spring. Failure to do so may result in damage to fuel injector. NOTE Remove fuel injection control linkage (WP 0320 00) if two or more fuel injectors are removed. 4. Rotate injector (10) clockwise to disengage injector rack (15) from control linkage (13). 5. Remove fuel injector (10) from cylinder head (7). 6. Remove O-rings (11) and (12) from fuel injector (10). Discard O-rings (11) and (12). 0319 00-2 TM 9-2320-386-24-1-2 0319 00 FUEL INJECTOR REPLACEMENT (Contd)