26. Install new O-rings (1) and (6) and fuel line (3) on adapter (8) of governor (7) and tee fitting (5), and tighten nuts (2) and (4). 27. Install bracket (12), with accelerator cable (10) and throttle control cable (11) attached, on governor (7) with two washers (13) and screws (14). 28. Install bracket (9), with accelerator cable (10) and throttle control cable (11) attached, on throttle lever (17) with washer (16) and nut (15). 29. Install new gasket (18) and crankcase breather base (19) on engine (29) with two washers (20), screws (21), washers (28), and screws (27). 30. Install breather tube (25) on engine (29) with spacer (26), clamp (22), washer (23), and screw (24). 31. Install ground (GND) strap (33) to stud (30) on firewall (31) with new lockwasher (32) and new locknut (34). 32. Install new O-ring (38) and fuel line (39) on elbow (36) at rear of cylinder head (37), and tighten nut (35). 7 ~ 8 1 2 3 4 6 5 7 ~ 15 16 17 9 10 11 12 13 14 TM 9-2320-386-24-1-2 0302 00 CYLINDER HEAD (IN-VEHICLE) MAINTENANCE (Contd) 0302 00-24