22. Install new gasket (15) and intake manifold (16) on cylinder head (6) with washer (14), screw (13), five washers (12), screws (11), fifteen washers (17), and screws (18). Tighten screws (11), (13), and (18) 13-23 lb-ft (18-31 N•m) in sequence shown. 23. Install clevis (24) on link pin (23) with retainer pin (22) and new retaining ring (19). 24. Slide sleeve (21) from cylinder head (6) and seat in governor (25). Install clip (20) on sleeve (21). NOTE Perform fuel synchronization (WP 0321 00) and adjustments (WP 0311 00, WP 0322 00, and WP 0323 00). 25. Install new gasket (10) and valve cover (9) on air intake manifold (16) with fourteen washers (8) and screws (7). Tighten screws (7) 45-99 lb-in. (5-11 N•m) in sequence shown. INTAKE MANIFOLD TORQUE SEQUENCE VALVE COVER TORQUE SEQUENCE 9 7 8 10 13 14 11 18 17 16 15 6 17 21 18 12 7 2 6 16 14 9 4 3 11 20 19 13 8 1 5 10 15 12 13 9 5 1 3 7 11 12 8 4 2 6 10 14 20 19 6 25 21 22 23 24 FRONT TM 9-2320-386-24-1-2 0302 00 CYLINDER HEAD (IN-VEHICLE) MAINTENANCE (Contd) 0302 00-23