CAUTION Rocker arms could disassemble on removal or installation. Handle with care. NOTE There is one rocker arm group for each piston. Perform steps 18 through 20 for one rocker arm group. Anchor is found on No. 1 cylinder rocker arm assembly only. 18. Install fuel injector pushrod (2) and two valve pushrods (1), as marked during removal, into cylinder head (6). 19. Install rocker arm assembly (5) on cylinder head (6) and pushrods (1) and (2). 20. Install anchor (3) and four screws (4) on rocker arm assembly (5) and cylinder head (6). Tighten screws (4) 13-23 lb-ft (18-31 N•m). 21. Repeat steps 18 through 20 to install other five rocker arm assemblies (5). 5 1 3 1 2 6 4 TM 9-2320-386-24-1-2 0302 00 CYLINDER HEAD (IN-VEHICLE) MAINTENANCE (Contd) 0302 00-22