16. Remove two nuts (21), screws (23), and washers (22) from radiator (27), and install ends of chain on radiator (27) with two washers (22), screws (23), and nuts (21). 17. Install lifting device at center point of chain and take up slack. 18. Remove four locknuts (29), screws (24), and washers (25) from pivot mount (26) and crossmember (28). Discard locknuts (29). 19. Remove locknut (20), washer (19), bushing (18), screw (14), washer (15), and bushing (16) from bracket (17) and bracket (13). Discard locknut (20) and bushings (18) and (16). 20. Disconnect oil line (30) from fitting (31) on radiator (27). .WARNING. All personnel must stand clear during lifting operations. A snapped chain, or shifting or swinging load may cause injury to personnel. CAUTION When removing radiator, avoid contact with the fan actuator hub. Contact between the radiator and fan actuator hub may cause damage to the radiator. 21. Lift radiator (27) from vehicle and lower onto pivot mount (26). 22. Tilt and lower radiator (27) to ground. 23. Remove two nuts (21), screws (23), washers (22), and chain from radiator (27). 24. Install two screws (23), washers (22), and nuts (21) on radiator (27) to avoid loss. 14 18 19 20 21 21 24 25 26 29 30 31 22 23 LIFTING DEVICE CHAIN 13 28 27 ~ 15 16 17 22 TM 9-2320-386-24-1-2 0302 00 CYLINDER HEAD (IN-VEHICLE) MAINTENANCE (Contd) 0302 00-7