TM 9-2320-386-10 CHAPTER 2 OPERATING INSTRUCTIONS Section I. Description and Use of Operator’s Controls and Indicators (page 2-1) Section II. Operator Preventive Maintenance Checks and Services (PMCS) (page 2-15) Section III. Operation Under Usual Conditions (page 2-48) Section IV. Operation Under Unusual Conditions (page 2-78) Section V. Operation of Special Purpose Kits (page 2-91). Section I. DESCRIPTION AND USE OF OPERATOR'S CONTROLS AND INDICATORS 2-1 Before you attempt to operate your equipment, ensure you are familiar with the location and function of all controls and indicators. This section describes the loca- tion and function of all controls and indicators. 2-1. KNOW YOUR CONTROLS AND INDICATORS NOTE • Except where specifically noted, the controls and indicators in this section are generally applicable to all vehicles covered in this manual. • In this manual, the term “left” indicates the driver’s side of the vehicle. The term “right” indicates the crew’s side of the vehicle. When a vehicle is received by the using organization, it is the responsibility of the officer-in-charge to determine whether it has been properly prepared for service by the supplier. It is the responsibility of the officer-in-charge to ensure the vehicle is in condi- tion to perform its functions. Maintenance personnel will provide any additional service required to bring the vehicle to operating standards. Before operating the vehicle, the operator must become familiar with the vehicle controls and indicators as described in this chapter. 2-2. PREPARATION FOR USE ________ WARNING ________ Hearing protection is required when maintaining vehicle with engine running.