TM 9-2320-386-10 3-4 MALFUNCTION NO. MALFUNCTION TROUBLESHOOTING PROCEDURE PAGE 3-3. TROUBLESHOOTING SYMPTOM INDEX (Contd) SPECIAL PURPOSE KITS (Contd) 38. Engine oil pan shroud not receiving heat (power plant heater only)................................ 3-17 39. Engine coolant system not receiving heat (power plant heater only)................................ 3-17 DEEPWATER FORDING KIT 40. Fording control handle inoperative .......................... 3-17 A-FRAME KIT 41. Winch inoperative .................................... 3-18 42. A-frame inoperative or misaligned ........................... 3-18 MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION NOTE If corrective action does not correct malfunction, noti- fy unit maintenance. ENGINE 1. ENGINE STARTER SWITCH IS ENGAGED BUT ENGINE FAILS TO START Step 1. Check to see if accessory/battery switch is off. If off, turn accessory/battery switch on (para. 2-3). Step 2. Check battery gauge for proper battery voltage (para. 2-3). Service batteries if gauge does not display proper voltage (para. 3-10). Step 3. Visually check to see if battery cables, terminals, and connections are loose, broken, or corroded. Check battery for proper water level. If loose, broken, corroded, or if battery water level is low, notify unit maintenance. Step 4. Ensure transmission is in neutral (para. 2-15). END OF TESTING! Table 3-1. Troubleshooting.