TM 9-2320-386-10 2-69 2-25. USING NATO SLAVE RECEPTACLE TO START ENGINE a. Position right side of slaving (recharging) vehicle to right side of disabled vehicle. b. Shutoff slaving vehicle engine. CAUTION When slaving, always connect slave cable to disabled vehicle first. Damage to batteries or cable may result from improperly connect- ing cable. NOTE Make sure electrical switches on both vehicles are in OFF posi- tion. c. Remove cover (3) from slave receptacle (1) and connect slave cable (2) to slave receptacle (1) on disabled vehicle. Repeat procedure on slaving vehicle. d. Start slaving vehicle engine and set idle speed at 1000-1100 rpm. e. Start slaved vehicle engine. f. After engine starts and is running smoothly, disconnect slave cable (2) from both vehicles. g. Put cover (3) back on receptacle (1). h. Clean and stow slave cable (2). i. Observe battery/generator indicator (4) on slaved vehicle. If indicator (4) does not reach green area, notify maintenance personnel. 1 2 3 4