TM 9-2320-361-34 I 3-13. OIL PRESSURE REGULATOR HOUSING MAINTENANCE THIS TASK COVERS: a. Removal d. Assembly b. Disassembly e. Installation c. Cleaning and Inspection INITIAL SETUP APPLICABLE MODELS All REFERENCES (TM) TM 9-2320-361-10 TOOLS TM 9-2320-361-34P General mechanic’s tool kit EQUIPMENT CONDITION (Appendix B, Item 1) ● Parking brake set (TM 9-2320-361-10). Spring tester (Appendix B, Item 38) ● Hood raised and secured (TM 9-2320-361-10). Inside micrometer (Appendix B, Item 16) Outside micrometer (Appendix B, Item 17) Torque wrench, l/2-in. dr. (Appendix B, Item 7) MATERIALS/PARTS Gasket (Appendix F, Item 83) Two gaskets (Appendix F, Item 51) Four lockwashers (Appendix F, Item 123) Crocus cloth (Appendix C, Item 7) a. Removal NOTE ● Perform steps 1 and 2 for vehicles equipped with engine models LD-465-1 and LD-465-1C. ● Perform step 3 for vehicles equipped with engine models LDT-465-1C and LDT-465-1D. 1. Remove screw (1) and lockwasher (2) from bracket (3) and engine (4). Discard lockwasher (2). 2. Remove three screws (1), lockwashers (2), regulator valve housing (6) and gasket (5) from engine (4). Discard gasket (5) and lockwashers (2). 3. Remove four screws (1), lockwashers (2), regulator valve housing (6) and gasket (5) from engine (4). Discard gasket (5) and lockwashers (2). 3-40