TM 9-2320-361-34 APPENDIX E (Contd) Tubing Application Tightening Assmbly Instructhns Slide tubing over barbed insert until it bottoms on MINI-BARB fitting. 1. Slide nut and then sleeve on tubing. 2. Slide I.D. of tubing onto fitting insert until it bottoms. 3. Assemble nut b fitting body. 4. Tighten assembly finger tight to cover body 1. 2. 3. 4. Slide nut and then sleeve on tubing. Slide I.D. of tubing onto fitting insert until it bottoms. Assemble nut to fitting body. Tighten assembly finger tight to cover body threads. 1. Cut tubing to desired length. Ensure ends are cut reasonably square. 2. Slide tubing into the preassembled fitting and push until tube bottoms. 3. Tighten nut as indicated in chart. Another check on proper assembly is dimension “A,” when nut is fidly tightened. REASSEMBLY- Push tubing and insert into DISASSEMBLY — Remove nut and pull tubing out of fitting body. Insert will remain on tubing. fitting body until it bottoms. Thread nut onto fitting body and tighten as in step 3. E-4