TM 9-2320-361-34 17-14. PERSONNEL HEATER FUEL LINE AND BLOWER HOUSING REPLACEMENT THIS TASK COVERS: a. Removal b. Installation INITIAL SETUP APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-34P TEST EQUIPMENT EQUIPMENT CONDITION Multimeter (Appendix B, Item 3) Personnel heater igniter removed (para. 17-13). TOOLS General mechanic’s tool kit (Appendix B, Item 1) Tool kit, electrical (Appendix B, Item 2) I a. Removal 1. Loosen nut (3) and remove fuel line (4) from fuel control valve (1). 2. Loosen nut (5) and remove fuel line (4) from burner fuel inlet (6). 3. Remove blower housing (2) from heat exchanger (7) and heater housing (8). b. Installation 1. Place blower housing (2) in heater housing (8). 2. Install fuel line (4) on burner fuel inlet (6) through blower housing (2). Do not fully tighten nut (5). 3. Install fuel line (4) on fuel control valve (1). Finger tighten nut(3). 17-34