TM 9-2320-361-34 I 16-16. POWER DIVIDER REPAIR (M764) (Contd) c. Assembly 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 16-86 Press bearing (6) and install new woodruff key (4) on shoulder shaft (5). Install gears (28) and (29) in housing (2) with shoulder shaft (5). Press bearing (27) in housing (2). Install nut (26) and new cotter pin (25) on shoulder shaft (5). Install cap (22) on housing (2) with four new lockwashers (23) and screws (24). NOTE Step 6 establishes shim pack starting thickness. Place cap (8) on housing (2) and measure distance between cap (8) and housing (2). Remove cap (8) from housing (2) and install new seal (9) in cap (8). NOTE Use measurement obtained in step 6 plus a 0.015 in. (0.381 mm) shim for starting shim pack thickness. Install new shim(s) (7) and cap (8) on housing (2) with four new lockwashers (11) and screws (10). Install bearing (16), spacer (20), bearing (19), spacers (18) and (17), and two washers (15) on gear (21). Install gear (21) in housing (2) with idler shaft (14). Install two nuts (13) and new cotter pins (12) on idler shaft (14). Install spring (32) and detent (31) in shifter fork (1). NOTE Detent may spring out of shifter fork during assembly. Install shifter fork (1) in housing (2) with straight rod (3). Install nut (30) on straight rod (3).