TM 9-2320-361-34 16-15. POWER DIVIDER REPLACEMENT (M764) THIS TASK COVERS: a. Removal b. Installation INITIAL SETUP APPLICABLE MODELS REFERENCES (TM) M764 LO 9-2320-209-12-1 TOOLS General mechanic’s tool kit (Appendix B, Item 1) 1-1/8-in. socket, 1/2-in. dr. (Appendix B, Item 10) 1-3/4-in. socket, 1-in. dr. (Appendix B, Item 42) Handle, socket wrench, 1-in. dr. (Appendix B, Item 43) Transmission and differential lift MATERIALS/PARTS Two cotter pins (Appendix F, Item 19) Cotter pin (Appendix F, Item 10) Four lockwashers (Appendix F, Item 140) PERSONNEL REQUIRED Two TM 9-214 TM 9-2320-361-20 TM 9-2320-361-34P EQUIPMENT CONDITION . Power divider drained (LO 9-2320-209-12-1). ● Power divider propeller shaft removed (TM 9-2320-361-20). ● Earth boring machine propeller shaft removed (TM 9-2320-361-20). . Air-hydraulic cylinder removed (TM 9-2320-361-20). . Power divider drivebelt removed (para. 16-18). GENERAL SAFETY INSTRUCTIONS Support power divider during removal and installation. WARNING Power divider is heavy. Support power divider during removal and installation. Failure to do so may result in injury to personnel. a. Removal 1. Remove cotter pin (2), clevis pin (1), and control rod (18) from lever (17). Discard cotter pin (2). NOTE Assistant will help with step 2. 2. Remove four screws (11), lockwashers (10), and power divider (4) from two brackets (3). Discard lockwashers (10). 3. Remove cotter pin (13), nut (14), washer (15), and seal (12) from input shaft (16). Discard cotter pin (12). 4. Remove cotter pin (7), nut (6), washer (8), and seal (9) from output shaft (5). Discard cotter pin (7). b. Installation 1. Install seal (9) on output shaft (5) with washer (8), nut (6), and new cotter pin (7). 2. Install seal (12) on input shaft (16) with washer (15), nut (14), and new cotter pin (13). NOTE Assistant will help with step 3. 3. Install power divider (4) on two brackets (3) with four new lockwashers (10) and screws (11). 4. Install control rod (18) on lever (17) with clevis pin (1) and new cotter pin (2). 16-78