TM9-2320-361-34 16-5. REAR WINCH REPLACEMENT (M764) THIS TASK COVERS: a. Removal b. Installation INITIAL SETUP APPLICABLE MODELS REFERENCES (TM) M764 TM 9-2320-361-20 TOOLS TM 9-2320-361-34P General mechanic’s tool kit EQUIPMENT CONDITION (Appendix B, Item 1) Sling (Appendix B, Item 14) ● Rear winch oil drain tubes removed (M764) (TM 9-2320-361-20). Lifting device ● Rear winch cable removed (TM 9-2320-361-20). MATERIALS/PARTS . Power divider removed (para. 16-15). Cotter pin (Appendix F, Item 10) ● Cab protector and mounting tubes removed (TM 9-2320-361-20). Six locknuts (Appendix F, Item 89) Four locknuts (Appendix F, Item 112) GENERAL SAFETY INSTRUCTIONS Sixteen lockwashers (Appendix F, Item 138) . All personnel must stand clear during lifting PERSONNEL REQUIRED Two operations. ● Ensure lifting capacity is greater than weight of winch. a. Removal 1. Remove cotter pin (14), clevis pin (16), and winch control clevis (15) from winch lever (13). Discard cotter pin (16). 2. 3. 4. 5. 6. Remove six locknuts (2), screws (4), and cap (3) from body (5). Discard locknuts (2). Remove four locknuts (18) and screws (17) from two rear winch frames (6) and subframe (8). Discard locknuts (18). Remove sixteen nuts (12), lockwashers (11), screws (7), washers (9), and two power divider brackets (10) from two rear winch frames (6). Discard lockwashers (11). Secure chain to rear winch (1) and lifting device. ● ● WARNING All personnel must stand clear of winch during lifting operations. A swinging or shifting load may cause injury to personnel. Ensure lifting capacity is greater than the weight of winch. Failure to do so may result in injury to personnel or damage to equipment. NOTE Assistant will help with step 6. Remove rear winch (1) from two subframes (8). 16-54