TM 9-2320-361-34 16-4. REAR WINCH REPAIR (M764) (Contd) 47. 48. 49. 50. 51. 52. 53. 54. 55. 56. 57. 58. 59. Remove three locknuts (25), bevel washers (24), screws (22), and tension roller (23) from frame (9). Discard locknuts (25). Remove cotter pin (31), nut (30), retainer (33), bearing (29), two clip rings (28), bearing (35), and pulley (34) from shaft (26). Discard clip rings (28) and cotter pin (31). Remove two packings (27) and grease fitting (32) from retainer (33) and shaft (26). Discard packings (27). Remove four screws (36), washers (37), and idler bracket (38) from frame (9). Remove adjusting screw (39) from frame (9). Remove jamnut (40) from adjusting screw (39). Remove cotter pin (17), clevis pin (48), and eyebolt (16) from control rod (18). Discard cotter pin (17). Remove cotter pin (19), clevis pin (46), and control rod (18) from lever (21). Discard cotter pin (19). Remove two locknuts (42) and screws (43) from levers (41) and (21). Discard locknuts (42). Slide levers (21) and (41) to center of shaft (45) and remove two woodruff keys (44) from shaft (45). Discard woodruff keys (44). Scribe position of jamnut (47) on control rod (18). Remove clevis (20) and jamnut (47) from control rod (18). Remove shaft (45) and levers (41) and (2) from frame (9). 16-31