3-3. para. 2-8. para. 2-9. para. 2-10. TM 9-2815-210-34-2-2 TM 9-2320-361-34 CAUTION 1. 2. 3. 4. 5. 7. 8. 9. 10. 11. 12. Do not allow lubricating oil to contact the surface on engine block where cylinder head gasket bonds. Cylinder head gasket may become contaminated with oil and fail to seal on engine block and cylinder head. Apply a thin coat of new engine oil on threads of fourteen studs (5) and nuts (1) facings. Locate point (11) on new gasket (3) approximately 2 in. (51 mm) above edge (13). Begin at point (11) and apply a thin, uniform coat of sealing compound approximately 0.5 in, (12.7 mm) wide along edge (13) on both sides of gasket (3) until reaching point (12) as shown. CAUTION Do not bind cylinder head against studs during installation. Bending of studs may cause cylinder head misalinement to guide pins. Cylinder head cannot be installed on engine block when this condition exists. Install new gasket (3) and cylinder head (2) on fourteen studs (5) and engine block (4) with fourteen washers (10) and nuts (1). NOTE If studs rotate when torquing nuts, remove cylinder head (task a) and replace or repair studs (para. 2-10). Tighten fourteen nuts (1) to 40 lb-ft (54 N.m) in torque sequence shown. a. Using torque sequence, tighten nuts (1) to 80 lb-ft (109 N.m). b. Using torque sequence, tighten nuts (1) to 110 lb-ft (149 N.m). c. Using torque sequence, tighten nuts (1) to 130 lb-ft (176 N.m). Install lifting bracket (9) and bracket (6) on cylinder head (2) with two new lockwashers (7) and screws (8). Install intake and exhaust manifolds (para. 3-17). Install and adjust rocker arms and pushrods (para. 3-7). NOTE Do not apply sealing compound on rocker arm cover gasket at this time. Install rocker arm cover and gasket (para. 3-6). Install fuel injector nozzles and holders (para. 5-2). Install air intake tube and cap (TM 9-2320-361-20). Connect battery ground cable (TM 9-2320-361-20). 3-6