TM 9-2320-361-34 16-3. REAR WINCH REPAIR (M756A2) (Contd) I g. Rear Winch Assembly 1. Apply thin coat of sealing compound to outer diameter of new seal (29) and install in drum (28). 2. Apply thin coat of sealing compound to outer diameter of new seal (40) and install in end frame (38). WARNING Support drum with overhead lifting device and chain. Failure to do so may result in injury to personnel or damage to equipment. 3. Install drum (28), drum thrust ring (43), two new woodruff keys (34), drum sliding clutch (42), and end frame thrust ring (41) on drum shaft (30). 4. Install two jamnuts (32) on rod (33) and install rod (33) on gearcase (31). NOTE Ensure shifter fork engages with sliding clutch when positioning end frame. 5. Position end frame (38) on rod (33) and drum shaft (30). 6. Install channel (35) on end frame (38) and gearcase (31) with four new lockwashers screws (37). 7. Install nut (39) on rod (33). 8. Tighten two jamnuts (32) to gearcase (31) and end frame (38). (36) and FOLLOW-ON TASK: Install rear winch (M756A2) (TM 9-2320-361-20). 16-23