TM 9-2320-361-34 I 16-2. FRONT WINCH REPAIR (Contd) 13. Install sleeve (27) in end frame (31). 14. Install three plugs (7), plug (6), and new pin (30) in end frame (31). 15. Install poppet (5) and spring (4) in end frame (31) with poppet nut (3). 16. Install poppet latch (2) on poppet nut (3) in lock position with two nuts (1). 17. Install new seal (19) on end frame (31) with plate (8), new lockwasher (9), and screw (10). 18. Install new woodruff key (17) and lever (12) on shifter shaft (18) with new lockwasher (13) and screw (14). 19. Position shifter shaft (18) in end frame (31) and install new woodruff key (11) on shifter shaft (18). 20. Pull shifter shaft (18) partially out of end frame (31) and position spring (15) and ball (16) in lever (12) and install shifter fork (22) on shifter shaft (18) with setscrew (25). 21. Install setscrew (20) and plug (21) in end frame (31). 22. Install drag brake (28) and spring (29) in end frame (31) with adjusting screw (32). 23. Install thrust ring (24), drum sliding clutch (23), and new seal (26) in end frame (31). 24. Install six spacers (33) on end frame (31) with six washers (34), new lockwashers (35), and screws (36). I g. Front Winch Assembly NOTE Ensure sliding clutch and woodruff keys are properly alined. 1. Install end frame (31) on rod (47) and drum shaft (43). 2. Install channel (37) on gearcase (45) and end frame (31) with six new lockwashers (38) and screws (39). 3. Install channel (40) on gearcase (45) and end frame (31) with four new lockwashers (42) and screws (41). 4. Install new locknut (50) on rod (47) and tighten two jamnuts (48). 5. Install plug (49) in end frame (31). 6. Install plug (46) in gearcase (45). 16-10