TM 9-2320-361-34 15-46. OUTRIGGER CONTROL VALVE REPLACEMENT THIS TASK COVERS: a. Removal b. Installation INITIAL SETUP APPLICABLE MODELS M764 TOOLS General mechanic’s tool kit (Appendix B, Item 1) MATERIALS/PARTS Four cotter pins (Appendix F, Item 22) REFERENCES (TM) LO 9-2320-209-12-1 TM 9-2320-361-10 TM 9-2320-361-34P EQUIPMENT CONDITION ● Parking brake set (TM 9-2320-361-10). . Hydraulic tank drained (LO 9-2320-209-12-1). Three lockwashers - (Appendix F, Item 125) Cap and plug set (Appendix C, Item 5) Antiseize tape (Appendix C, Item 25) CAUTION When disconnecting hydraulic lines, plug all openings to prevent dirt from entering and causing internal parts damage. Prior to installation, remove plugs from openings. Failure to do so may result in damage to equipment. a. Removal NOTE . Tag hoses for installation. ● Have drainage container ready to catch oil. 1. Remove six hoses (2) and elbows (7) from control valve (9). 2. Remove four cotter pins (5), straight pins (4), and two control levers (3) from control valve (9). Discard cotter pins (5). 3. Remove three screws (6), lockwashers (8), and control valve (9) from body (1). Discard lockwashers (8). I b. Installation I NOTE Apply antiseize tape to male pipe threads before installation. 1. Install control valve (9), three new lockwashers (8), and screws (6) on body (1). 2. Install two control levers (3), four straight pins (4), and new cotter pins (5) on control valve (9). 3. Install six elbows (7) and hoses (2) on control valve (9). 15-204